Introduction and question

[Crowndog]

Howdy all,
New to this forum and I hail from Pa. Been collecting and shooting Colt SAAs for a bit.
I recently acquired a 1st gen Frontier Six Shooter. Had the barrel re-qualified to correct the barrel cylinder gap and had the correct Smith Ent. bolt and hand put in and timed by Jim Martin. The next issue to address is remarking the barrel and other roll stamps and refinishing the gun. It has a terrible buffed and reblue job.
I'm looking for recommendations on who might do good work like this?
Thank you.

[St. George]

Dave Lanara can do it - whether he will or not remains the question.

Doug Turnbull will do it if you pay him enough.

Scouts Out!