Cutting and trimming brass for 56/56

[wolflobo76]

Here is my next attempt at posting some pics.  The following pics are the step by step way I cut and trim the 50/90 starline brass  to make cases for my 56/56. The case OAL for this batch is 1.062. My last batch was trimmed at 1.05.  Keep in mind that this is just my Low Tech way of doing this due to time availiablility. I only due a handfull of cases at a time.


I marked the case at 1.075 and locked it in my lyman case trimmer

 Then broke out my high dollar 10 inch saw and went to work





  I  then trim to 1.062

     untrimmed case on the left and final product on the right that is also deburred and slightly chamfered