Uberti Cattleman BH .45LC 4" question

[Sundown Storm]

Hello, Ladies and Gents;
Been a while since I was on the board, and it's good to be back, I must say.
I bought an Uberti Cattleman BH .45LC 4" barrel today, wonderful looking piece - get it home, and the basepin screw is missing from the front (It's an old-style frame, so the screw goes in the front of the pistol). Is this a screw I can get from a gunsmith, or am I going to have to go through the rigamarole of gettin' one from the Manufacturer?


thanks, in advance,

Sundown

[Long Johns Wolf]

There should be a spare one in a little plastic bag underneath the "X area" of the carton.
Bootsie

[Sundown Storm]

unfortunately, there wasn't

[Arcey]

Howdy, Sundown.

Ya might wanna ask this question over in Gunsmithing.

[RRio]

Hello, Ladies and Gents;
Been a while since I was on the board, and it's good to be back, I must say.
I bought an Uberti Cattleman BH .45LC 4" barrel today, wonderful looking piece - get it home, and the basepin screw is missing from the front (It's an old-style frame, so the screw goes in the front of the pistol). Is this a screw I can get from a gunsmith, or am I going to have to go through the rigamarole of gettin' one from the Manufacturer?


thanks, in advance,

Sundown

I gotta spare I can send ya. PM me with your address.

[Driftwood Johnson]

Or you could call up VTI gunparts. They are usually much easier to deal with for spare parts than the manufacturers.

[Dr. Bob]

I'll second Driftwood's idea.  Called this noon and they expedited getting my parts out this afternoon!  Real service!!   Very helpful in finding the right thing too!