Recommend a gunsmith?

Started by Tubac, January 04, 2007, 04:48:32 PM

Previous topic - Next topic
Print
Go Down Pages1
User actions

Tubac

January 04, 2007, 04:48:32 PM
Would you fellas have any 'smiths you'd recommend to bore out a cylinder from .44 to .45?
Thanks gents,
Tubac
from the Confederate Territory of Arizona

Sagebrush Burns

#1
January 04, 2007, 10:42:15 PM
Hamilton Bowen comes to mind.

RRio

#2
January 05, 2007, 01:02:35 AM
Tom Sargis at Bozeman Trail Arms:

http://www.ycsi.net/users/gunsmith/
"I hate rude behavior in a man. I won't tolerate it"  - Capt. Woodrow Call

"Proud citizen of CasCity since 2004." 
NCOWS 2492  SASS 22927   SCORRS     USFACS #28       GAF #267 Dept. of the Platte  AZ        STORM #178

Mustang Gregg

#3
January 05, 2007, 04:18:47 AM
You didn't mention what cylinder.
Cuttin' out a Ruger cylinder?  Probably a safe project.   ;D
Not a '72 Open Top, is it?  :o  Them might be too thin to cut any bigger.
Or are you talking about a BP six-gun?
"I have two guns.  {CLICK--CLICK}  One for each of ya."
  BACK FROM AFGHANISTAN!!
"Mustang Gregg" Clement-----NRA LIFER, since '72-----SASS Life & Territorial Governor-----GAF #64-----RATS #0 & Forum Moderator-----BP Warthog------Distinguished Pistol 2004------SAIROC & MMTC Instructor-----Owner of Wild West Arms, Inc. [gun shop] Table Rock, NE------CASTIN' & BLASTIN'!!!!
www.wildwestarms.net

Mustang Gregg

#4
February 01, 2007, 08:22:59 PM
BTF
"I have two guns.  {CLICK--CLICK}  One for each of ya."
  BACK FROM AFGHANISTAN!!
"Mustang Gregg" Clement-----NRA LIFER, since '72-----SASS Life & Territorial Governor-----GAF #64-----RATS #0 & Forum Moderator-----BP Warthog------Distinguished Pistol 2004------SAIROC & MMTC Instructor-----Owner of Wild West Arms, Inc. [gun shop] Table Rock, NE------CASTIN' & BLASTIN'!!!!
www.wildwestarms.net
Print
Go Up Pages1
User actions
© 1995 - 2024 CAScity.com