Going back into molding my own bullets

[Boone May]

Greetings pards,
I usually hang around the Winchester 1876 forum but thought I would check in here.  After many years of buying my lead bullets from Buffalo Arms and others I have decided to get back into molding my own.  Years ago I did it, but then decided I could get all the bullets I wanted from commercial sites.  I even gave away my RCBS bottom pour furnace.
Well, the days of finding reloading components (including lead bullets for the obsolete caliber guns) are gone.   I have been frustrated by the lack of available commercial bullets for my old Winchester rifles. 
I still have molds for my favorite old west cartridges.  So I ordered a new RCBS Pro Melt furnace.  Looking forward to getting back into molding my own. 
How do you folks divvy up your lead and tin to get a 20 to 1 ratio?  That seems to be the secret sauce for loading black powder cartridges for obsolete guns like the Winchester model 1876 in .45-75

[Froogal]

I just buy the 20-1 lead ingots from Roto-Metals.

[mtmarfield]

     Greetings!

   If your range / shooting area allows, dig that lead out of the embankment. I'll separate out the very hard "Cowboy Action" bullets from the soft / swaged and jacketed bullets; when I fire up the pot, I'll add the harder bullets to the softer melt a small handful at a time. I like my bullets to be between 13BHN to 15BHN or so for the average CAS handgun and rifle cartridges.
   Sorry, I can't be more specific about my lead / tin / antimony ratios; I use my LBT Hardness Tester to give me an idea of where my bullets are. I believe that most factory CAS Ammo is loaded with bullets that are FAR HARDER than they need to be; so, when I dig them up, I use them to harden my melt. Have Fun!

                     M.T.M.

[Little Dalton]

Good on ya and have fun! It's worth noting that straight wheel weight lead is near identical to a 20:1 alloy in hardness. Rather handy. I still get gobs of wheelweights from small town shops for cheap, just gotta separate the zinc and iron weights out.

[Slamfire]

 Been casting my own for a while but have been powder coating as of late for my 40-60 Chappie & my 44-40, barrels stay super clean, but shoots the same as lubed bullets, think i'll stay with it for now.

coffee's ready,  Hootmix.

[Drydock]

 Rotometals.  40 lbs of 20-1 gets free shipping.  My 50-70s go through a lot of lead.