Fluted or non fluted 1860

Started by Qball, February 18, 2009, 05:54:57 AM

Previous topic - Next topic

Qball

Lot's of fluted 1860 now  ;D
Thinkin' of modifying my non fluted -60 to fluted. Any thing in particular to think of before i start?
Is it even possible to do? Gun laws is different here in Sweden so a new one is not an option for me.
The make of the gun is ASM, but it's all i got.

Thank you for any comments.
WartHog
SCORRS
SootLord
STORM

Long Johns Wolf

Easiest way would be a fluted replacement cylinder if legally an option.
When you wish to have your factory supplied rebated cylinder fluted you may want to check the interior depth of the chambers before starting. If the chambers reach down to include (part of) the bolt notches (like in 1st and 2nd gen 1860s) AND you like to shoot power loads all the time you may want to reconsider the fluting project.
An issue to consider is proper hardening the newly fluted cylinder.
Initiates have different opinions regarding (safe) chamber sizes of fluted cylinders in the 1860 Army.
We recently measured quite a number of Centaure C&B revolvers ("1960 NEW MODEL ARMY). Different chamber measurements were found from as far down to about the base of the nipples to as short as to only were the rebate portion on the outside of the cylinder begins. Interestingly, early production Centaure revolvers have the deep chambers, later production pistols have short chambers. Chamber sizes were reduced in 2 steps to the final short version. It appears that the last reduction of the interior depth of the chambers by the Belgian factory coincides with the introduction of the regular New Model Army with fully fluted cylinder. For details of that study check www.1960nma.org and browse down the page "Major Characteristics" til you reach the chapter about the chamber size.
Long Johns Wolf
BOSS 156, CRR 169 (Hon.), FROCS 2, Henry Board, SCORRS, STORM 229, SV Hofheim 1938, VDW, BDS, SASS

Henry4440

Quote from: Long Johns Wolf on February 18, 2009, 07:50:00 AM
www.1960nma.org
Long Johns Wolf

Wow, that is a very nice looking stainless full fluted 1860 Army.
(7th Variation: even rarer are stainless steel versions that have surfaced in Europe and the USA, manufactured during 1972. Like the afore mentioned 6th variation they sport fluted cylinders, see S/N 12307:)

Btw, a very interesting website.
;)

Qball

Thank you Long Johns Wolf.
Lots of interesting reading on your site, very impressive.
WartHog
SCORRS
SootLord
STORM

© 1995 - 2024 CAScity.com