Ejector for a Remington Beals Navy Conversion

[Tubac]

Hi Gents,
Do any of you fine folks know of someone who makes ejectors for Remington conversions?
I've an original Beals Navy conversion that's missing the ejector, and I like to find one that could be made to fit.
Thanks for your help.

Tubac

[Halfway Creek Charlie]

Email Ottawa Creek Bill on the this sight. He has made a couple for his conversions (Colt).He could probably make you one from McDowell's book. I think he has a copy.
He won't be able to get to it until he gets back from the Elk hunt in October though.

[Major 2]

Just the rod or the dovetailed fixture too ? ...Just the rod should be simple

I also would contact OCB

[Tubac]

Major,
I need the whole shootin match, rod, and ejector housing.
I'm guesin that the housing would have the means to mount it to the revolver.

Tubac

[Halfway Creek Charlie]

Tubac,
I believe that if you look closely at the pistol, the flat area in front of the cylinder in the frame was milled as a dovetail the whole length. The Rammer screw tightens against the dovetailed ejector housing. there is a sprin clip on the housing that hold the ejector and keeps it from slipping out of the housing. the ejector itself is a rod bent 90 degrees and flattened and crosshatched on the end that rests in the rammer notch on your rammer. That is why your cylinder pin has only one ear too.

Easy for me to say right guys....Tubac sent me pictures of this pistola.

There are a few guys that have made them but I cannot recall who right off.  OCB would be my go to guy to ask.

[Major 2]

Being as how the Beals is some what smaller than the NMA... I wonder if the Uberti Forged frame conversion part might be a fit.
Suzanne Webb is sending me the tiny little screw that holds the spring, but she might also be the source for the dovetail ,spring and rod...
just thinking out loud 

OCB offered to make my missing screw, he'd be my go to guy... if Webb does not come through.