I have posted a imagine, please look and advise!

[Ace Lungger]

 :)howdy Fellows,
I am in need of a 2D - 3D , Of a bird dog, It can be Head & shoulders needs to be about 1"x1" or a little bigger. If you have or know where I might get one one, please PM me. i have a small job to do, a but cover for a SXS Shotgun, and I have to put a Bird dog on both sides.
thanks ACE

Fellows, I need your advice again!! Lets say I buy this belt buckle, and cut around the head so no other marking show will this work or not??

[Ace Lungger]

I was wondering if I found a Remington Belt Buckle with the Bird dog on it, would that work? As you can tell I am drawing for staws here!
If anyone knows where I could buy a plastic traceable, maybe I could Carve it?
I am open for any thoughts.
ACE

[knucklehead]

dont know about any stamps.
you could check tandyleatherfactory.com to look at their stamps.

you might also try colloring books for dogs. if you can scan the pic into a computer then you can shrink it to fit

[Ace Lungger]

Thanks  knucklehead, But I can't carve!
i will keep looking!
Thanks alot
ACE

[Ace Lungger]

Bump, need advice PLEASE!
Ace

[Dalton Masterson]

Ace, before cutting it, put some masking tape over the details you dont want to show, and then try it. I may work, if you put it in a press. I will experiment a little with some of my buckles and see if it gives a decent impression. DM

[Ace Lungger]

 :)Howdy Dalton, Thank you for replying, the problem is I don't own that buckle, i was going to have to buy it off ebay! i have search and search and search, for any type of bird dog stamp, i dont own any buckle's with a raised emblem.
Thank you for the help, it is back to where I started!
Later ACE

[cowboywc]

Ace
I found 2 craftaids with dogs. I sent you an e-mail and it came back, I also sent you a PM.
WC

[Ace Lungger]

WC, I sent you a pm.
ACE