Broken shell extractor for .45 Colt?

[RattlesnakeJack]

Does anyone know where I can get a broken shell extractor for .45 Colt?   

Brownell's used to have such an animal, but has discontinued it ... 

Alternatively, does anyone know if the one they still carry for .44-40 might work for .45 Colt?

[Big Dipstick]

Brownells does have a lead like product called Cero-Safe, you melt it down and pour it in the chamber after you have put a patched jag into the muzzle stopping b-4 the chamber.

The stuff works great and can be used over & over, it melts at a very low temp and can even be lelted with boiling water.

[RattlesnakeJack]

Brownells does have a lead like product called Cero-Safe, you melt it down and pour it in the chamber after you have put a patched jag into the muzzle stopping b-4 the chamber.

The stuff works great and can be used over & over, it melts at a very low temp and can even be lelted with boiling water.

That method has been used successfully to clear the stubborn separated cases I've had in the past - but a broken shell extractor works in seconds, right there in the field/on the firing line where the problem occurs - letting you get back into action immediately - a very important consideration in timed competitions.  Even the "tight borebrush on a rod" method (which may work ... or may not, particularly if you've only noticed the problem after trying to chamber another round) effectively puts you out of action for that particular stage, since it requires moving to an unloading table  or other safety area to perform the procedure ...

[Sir Charles deMouton-Black]

Jack;  I'd forgotten about it.  The old target shooters talked about using a TIGHT borebrush to push the broken case out.  Apparently works, except if the fragment is seized.

[RattlesnakeJack]

Sir Charles:

Yes, have also used that method, but with little success - The problem is that, with a lever-action rifle being fired rapidly in the "heat" of a scenario, one generally doesn't notice the case separation until you've tried to ram another loaded cartridge into the chamber - which definitely does tend to jam the shell fragment in quite firmly! 

At any rate, as mentioned just above - even if a tight borebrush will push out the broken case, that method is of little use to save the situation when the problem occurs in the middle of a shooting stage .... 

That is why I am so interested in getting a broken shell extractor for .45 Colt - a nifty little gizmo which can be carried in a vest or shirt pocket and, if the need arises, can be quickly inserted partway into the chamber, whereupon you just cycle the action to extract the cartridge remnant.  Having now seen one in operation (as stated in the other thread I started - in the Coffee Cup, I think) I couldn't believe how well it worked, or how I've done without this long ....   

Which brings me back to the original problem - the only place I could find online who even list a .45 Colt version is Brownells, but they have discontinued it! 

[Sir Charles deMouton-Black]

Jack;  In the Army, I saw one of our "Tiffies" make one on a lathe.  Make a dummiy with the shape of the case but a bit longer.  Relieve the front somewhat, to form a hook, just forward of where the mouth would be.  The front, ahead of the hook should be bevelled.  Saw & file a slot down the result and "splay" the mouth out a bit.  load it, close the action, and it should slip over the front of the fragment.  Working the action should do the trick.  Unfortunately I can't quite recall the exact shape, so you might have to X-spearmint.

Good luck!

BTW "Tiffy" is the nickname used in the Artillery for a armament "Artificer"