Print Page - Need some work done on some open tops

Title: Need some work done on some open tops
Post by: Two Bit Charlie on August 09, 2019, 10:08:22 AM

Hello the camp.
I need a suggestion on someone to work on my open tops. I have 4 Uberti conversions that need the arbors fixed and then slicked up for competition. Two of them have bolt lock up issues. I also have 3 cap guns which will need arbor work. Any suggestions will be appreciated.

Two-Bit Charlie

Title: Re: Need some work done on some open tops
Post by: Johnson Barr on August 09, 2019, 12:13:54 PM

Sheboygan, give our brother OK Tom a call. He will make yer OT's shine. -Johnson Barr

Title: Re: Need some work done on some open tops
Post by: Isom on August 20, 2019, 02:08:40 PM

Try, Goon's gun works.

Title: Re: Need some work done on some open tops
Post by: Coffinmaker on August 21, 2019, 09:59:00 AM

Isom,

Would also be my suggestion ...... EXCEPT ....... Da Goon is not an FFL holder (last I knew) and cannot receive cartridge guns. Strictly a Cap Gun guy (last I knew). Perhaps Mike will wade in and either confirm or deny the allegations :D

Title: Re: Need some work done on some open tops
Post by: 45 Dragoon on August 21, 2019, 10:15:05 AM

Thanks Isom!!

Coffinmaker, you are correct (and thanks!), but I do have an ffl to receive and ship for me. So, it is possible. I've done quite a few O.T.s and Rem. conversions.

Two Bit, you can reach me through my website or PM here.

Thanks again guys!!

Mike

Title: Re: Need some work done on some open tops
Post by: River City John on September 27, 2019, 03:51:40 PM

I second OK Tom!

Reasonable, knowledgeable and very experienced. Cowboy firearms are all he specializes in.

Did wonders on my '58 Remington and Leech & Rigdon. (Plus he got me out of a scrape when my '66 malfunctioned in the middle of a match. Add kudos to J. Barr on that, too.)

RCJ

Cas City Forum Hall & CAS-L

CAS TOPICS => The Darksider's Den => Topic started by: Two Bit Charlie on August 09, 2019, 10:08:22 AM